iFlight Chimera7 6S LR BNF: 7 '' long range FPV bird.

Contents

1 Developer about the new product
2 Features
3 Components
4 Specification
4.1 Frame
4.2 PC
4.3 ESC
4.4 Motors
5 Price

Developer about new

The iFlight Chimera7 is a super-efficient 7-inch long-range bird that can go where you never thought possible, capable of carrying large batteries to extend flight times, so you can ride around the Swiss Alps if you want! The quad is built on a super-rigid frame for minimal resonance, which is powered by XING 2806.5 motors in tandem with 7-inch props. Fly with large top-mounted batteries or even larger bottom-mounted batteries. To realize the maximum potential, it is better to use 6 cans of food, and for a measured flight, 5 cans of Lipo / Lion are suitable without any problems. Recommended 5S for 3000 mAh and above (for measured cruising) or 6S for 2500 mAh and above (for high-speed cruising).

Features

Weight (without battery) 628.1 g
Pre-tuned from the factory (PID Filter tuning)
Ultra-rigid carbon frame with 6 mm beam thickness
Diagonal frame size 320 mm
Flight controller: SucceX-D F7 2.1 TwingG (MCU: 216 MHz STM32F722; Firmware: Betaflight)
ESC: SucceX 4 in 1 50A 2-6S Dshot1200
Motors: Used iFlight XING 2806.5 1300KV / 1800KV (optional)
Propellers: 3-blade Gemfan 7040
FPV: DJI Digital FPV system
2 × 150mm 5.8G Albatross LHCP RP-SMA Antennas
GPS module (customizable GPS Rescue Betaflight)
Flight Modes: Acro / Angel (default Angel)
GoPro TPU bottom mount
360 ° TPU protection DJI cameras and VTX antenna mounts
Props are out of sight of the FPV camera
Battery voltage LED torus
Recommended power supply: 5S 3000 mAh and above (for measured cruising) or 6S 2500 mAh and above Lipo / Lion with XT60 connector.
The ability to install the battery from the top and bottom

Options

The developer offers a drone with two model options motors to choose from iFlight XING 2806.5 1300KV Cruiser / 1800KV Speed Cruiser in two BNF configurations:

Without receiver (for owners of DJI control equipment)
With TBS Crossfire NANO RX receiver

Spare kits for GemFan 7040 3-blade props (2 sets / 4 pairs), spare pair of front or rear beams are also available as options, DJI FPV goggles, DJI control equipment (Mode 1 / Mode 2), TPU mounts with a tilt angle of 0-40 ° for various versions of GoPro action cameras (5/6/7/8 series).

Specification

Frame

Name:

Chimera7

Material:

Carbon Fiber

Diagonal size:

320 mm

Main frame size:

258 × 199 mm

Distance from top to bottom:

20 mm

Beam thickness:

6 mm

Bottom plate thickness:

3 mm

Top plate thickness:

2 mm

Thickness of the upper (middle) plate:

3 mm

Thickness of the chamber plate:

3mm (TPU insert included)

PC

Name:

SucceX-D F7 V2.1 TwinG

MCU:

Chimera7

Gyroscope:

2 × ICM20689

Barometer:

yes

Blackbox:

32Mb

Betaflight OSD:

yes

BEC:

5V 2.5A / 9V 2.5A

Current sensor scale:

100

Inverter for SBUS input (UART2-RX):

yes

Smartaudio and Tramp VTX support:

yes

Soundbar:

yes

RSSI Input Panel:

UARTs:

Motor outputs:

ESC port:

8-pin 4-in-1 port (GND, VBAT, M1, M2, M3, M4, CUR, R5)

DJI Air Unit port:

6-pin port (R1, GND, R2, T2, GND, 9V)

BLHeli32 telemetry:

RX5

Input voltage:

2-6S recommended, Max 8S

Firmware Target:

IFLIGHT_F722_TWING

Installation diagram:

30.5 x 30.5 mm Ø4 mm with Ø3 mm bushings

Dimensions:

36 x 36 mm

Weight:

7.5 g

Peripheral connector:

USB type-C

ESC

Name:

ESC // SucceX 50A

MCU:

STM32F051

PWM frequency:

to 48 kHz

Capacitance: [2 30]

470 μF / 50V

Current sensors:

yes

Input power:

2-6S LiPo

DC / Peak:

50A / 60A

BlHeli32 telemetry:

yes

BEC:

Supported protocols:

Dshot1200, Proshot, Oneshot, Multishot

Firmware Target:

iFlight-BL32-4IN1

Weight:

14.4 g

Installation diagram:

30.5 × 30.5 mm / Ø3 mm

Dimensions:

43 × 39 mm (including pads)

Motors

Name:

XING X2806.5 FPV NextGen Motor

Voltage:

2-6S

KV:

1300/1800

Configuration:

12N14P

Bearing:

NSK / 11 × 5 × 5

Stator diameter:

Stator length:

6.5 mm

Shaft diameter:

Supported power supply:

2-6S LiPo

Weight (with short cable):

49.5 g

Mounting holes:

19 × 19 mm Ø3 mm

Price

Currently, the new iFlight Chimera7 6S LR BNF is available for pre-order on the official website of the developer. Prices depending on the selected configuration: